To configure Storage Works disks connected to a swxcr controller:

 1. Insert the diskette into the drive
 2. At the boot prompt enter arc. This invokes diagnostic mode from which
    there are various menus which can be used to show/change the
    configuration.
 3. From the menu select run a program
 4. enter swxcrmgr -o
 5. Configure the disks by following the prompts

To configure Storage Works disks connected to a HSZ50-AX controller, use hszterm e.g.

hszterm -b 1 -t 0 -l 0

or dxhsz for the GUI version.

Note: Information about bus, target and lun numbers can be found using command uerf -R -r 300

Recent Changes

Contribute to this wiki

Why not help others by sharing your knowledge? Contribute something to this wiki and join out hall of fame!
Contact us for a user name and password